Paradyne COMSPHERE 3800 Series Modems 3810 Manual de usuario Pagina 37

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 204
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 36
COMSPHERE 3800 Series Modems
4-10 November 1996 3810-A2-GB30-20
Table 4-4
(3 of 3)
Top-Level Menu Status
Dial Backup
Messages
Indicates
Dial Standby The modem is operating in Dial Standby mode.
DialBckUp:
MR*
The modem is operating in a Dial Backup mode at the displayed data rate and is configured for
Direct mode.
Backup:
MR* EC**
The modem is operating in Dial Backup mode and is configured for error control and data
compression on leased lines.
Stndby:
MR* EC**
The modem is operating in Dial Standby mode and is configured for error control and data
compression on leased lines.
Firmware
Download Result
Messages
Indicates
DownldOnly
Mode
Indicates that a local download of firmware or a remote cloning of firmware has failed. The
modem is currently in a Download Only mode in which only another download attempt is possible.
Frmware Upgrade Indicates that a local download of firmware or a remote cloning of firmware was successful.
RemClone Failed Displays on the local modem’s LCD and indicates that a remote cloning of firmware has failed.
Remote Clone OK Displays on the local modem’s LCD and indicates that a remote cloning of firmware was
successful.
AT Command
Reset Message
Indicates
Reset by AT
command
The modem has performed a reset in response to an ATZ command.
* MR. Modem Rate indicates the data rate the modem is using. One of the following values appears: 300, 1200, 2400,
4800, 7200, 9600, 12K (12,000), 14.4 (14,400), 16.8 (16,800), or 19.2 (19,200) bps.
** EC. Error Control indicates the modem is online and using V.42 or MNP error control. One of the following values
appears after the modem rates listed above: MNP2, MNP3, MNP4, MNP5, V42, V42b, or NoEC. (NoEC indicates the
modem is connected in Buffer mode rather than error control. If an EC value does not appear, then the modem is in
Direct mode.)
Vista de pagina 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 203 204

Comentarios a estos manuales

Sin comentarios